The DT4122 … Resistance Thermometer enable process temperature or resistance value to be displayed on the control panel Pt100 / Pt500 / Pt1000 temperature sensor, resistor or potentiometer can be connected to the input of the instrument, either with 2, 3 or 4 wire. Large 5 digit, 20.3 mm character height LED display make process value easily visible at a distance.
The instrument is available with the following output options:
- 2 normally open relay contacts (SPST) for limit switching or for simple control tasks
- 0-20 mA / 4-20 mA galvanic isolated scalable current output *
- RS232 / RS485 galvanic isolated communication output with MODBUS RTU slave protocol *
- transmitter supply galvanic isolated 15 VDC 20 mA*.
(* either analogue or communication or transmitter supply option can be implemented at the same time)
The functional parameters can be set by push-buttons on the front panel of the device, through a simple menu system: input selection, averaging of input signals, scaling, display frequency, limit values, limit operating modes, scaling the analogue output, etc. The settings are protected by a two-level password against unauthorised manipulation.The Thermometer able to calculate with three sensor calibration point, to fit the real sensor curve to the instrument. The instruments has two power supply versions: 18-40 V AC/DC (DT4122 …) or 180-250 V AC/DC (DT4122 … PS).
The DT4122 … is housed in a DIN standard 138 × 68 mm ABS case with IP 65 protection from the front and IP 30 protection from the back side, for installation on the control panel.